Epoxy floorings are floors installed with layers, long-wearing coating known as epoxy. Epoxies can be used to create glowing, clean and sturdy flooring. Additionally, it is used to shield paint on the floors from oil, grease along with other chemicals. Nevertheless, only a few floorings can support epoxy coating. Therefore, before you decide to use epoxy on the floors, you need to evaluate initially the condition of your current concrete whether it creates moisture or not. Floors that generates moisture generally damage the capability of the epoxy to bond. For this reason, it is not best for epoxy coating.
Also, you should never use epoxy coating if the floors was applied with concrete sealer. However, when you have a new slab, look ahead to at least a month for the floors to be completely dry before epoxy application. Plus, when you have painted floors, your best option is to take away the outdated paint prior to using any type of epoxy. Additionally, you must think about the air temperature in the garage. For maximum epoxy drying, air temperature must be around 70 and 80 degrees with the least concrete temperature of 50 degrees F.
The result of the epoxy flooring also is determined by your own planning and also pre work. Pre work includes floor cleaning and degreasing, oil spot removal, floor etching with minimal acid, and also floor vacuuming, scrubbing, and rinsing. When your flooring does not have any cracks, you may quickly apply the first layer of epoxy. On the other hand, when your floor possesses cracks, it’s a good idea that you fill up the cracks before using the first layer of epoxy. The 2nd layer of epoxy is put on the next day.
Another crucial decision you need to make is the kind of epoxy you need to use. Epoxy floor coatings are usually hard resins, which are available into 2 different parts. You will find 3 kinds of epoxy: solvent-based, 100 percent solids, and also water-based. The first one pointed out on the list is nearly pure epoxy. It does not have solvent. Therefore, it is quickly dried up and is hard to handle. This type of epoxy is best left to the specialists.
